Installing The Ac Power Supply - Brocade Communications Systems NetIron CES Series Hardware Manual

FIGURE 39
5. Continue to pull the power supply until it is removed from the device.
6. Place the power supply in an anti-static bag for storage.
7.

Installing the AC power supply

Perform the following steps to install an AC power supply.
1. Remove the power supply or cover plate currently in the power supply bay you wish to install
2. Remove the new power supply from its packaging.
3. With one hand, support the underside of the power supply and insert the power supply into the
Brocade NetIron CES and Brocade NetIron CER Hardware Guide
53-0000080-03
Removing the power supply from the device
Insert a new supply, or place and screw in a cover plate over the empty power supply. Refer to
"Installing the AC power supply"
the power supply in. Refer to
empty power supply slot. Press until the supply is completely in the slot, so that the connectors
on the back of the supply are fully engaged with the pins on the power backplane.
on page 61 for details.
"Removing the AC power supply"
Power supply replacement
on page 60 for details.
5
61