Adjust The Volume; Configure The Intercom Parameters - CyberData 10935 Operation Manual

2.1.9 Adjust the Volume

You can adjust the volume through the

2.2 Configure the Intercom Parameters

To configure the Intercom online, use a standard web browser.
Configure each Intercom and verify its operation before you mount it. When you are ready to mount
an Intercom, refer to
All Intercoms are initially configured with the following default IP settings:
When configuring more than one Intercom, attach the Intercoms to the network and configure one at
a time to avoid IP address conflicts.
IP Addressing
IP Address
Web Access Username
Web Access Password
Subnet Mask
Default Gateway
Operations Guide
Appendix A, "Mounting the Intercom"
Parameter
a
a
a
a. Default if there is not a DHCP server present.
Speaker Volume
Table 2-4. Factory Default Settings
DHCP
10.10.10.10
admin
admin
255.0.0.0
10.0.0.1
930242A-D
Installing the VoIP Intercom
setting on the Device Configuration
for instructions.
Factory Default Setting
CyberData Corporation
25
Intercom Setup
Page.