CyberData 10935 Operation Manual page 44

2.2.5.2 Point-to-Point Configuration
When the board is set to not register with a SIP server (see
intercom to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The Intercom can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 2-20. SIP Configuration Page Set to Point-to-Point Mode
Intercom is set to NOT register with a SIP server
930242A-D
Installing the VoIP Intercom
Figure 2-20), it's possible to set the
CyberData Corporation
38
Intercom Setup