CyberData 10935 Operation Manual page 30

2.1.8.2 Intercom with a Jumper
Complete the following steps to restore defaults on an Intercom that has a jumper and no RTFM
button:
1. Put a jumper on JP11. See
2. Wait for the Intercom to announce the IP address.
3. Press and hold the Call Button (see
4. Release the Call Button and wait for the Intercom to reboot.
5. Remove the jumper and cycle power by unplugging Intercom and plugging it back in.
Operations Guide
Figure 2-14.
Figure 2-14. Jumper on JP11
Figure 2-15. Call Button and Call Button LED
930242A-D
Figure 2-15) until "restoring defaults" is announced.
Call Button and Call Button LED
Installing the VoIP Intercom
Intercom Setup
CyberData Corporation
24