Call Button And The Call Button Led - CyberData 10935 Operation Manual

2.1.4 Call Button and the Call Button LED

2.1.4.1 Calling with the The Call Button
•
•
•
•
2.1.4.2 Call Button LED Function
•
•
•
•
•
•
Operations Guide
You may initiate a call by pressing the Call button.
An active call is indicated by the Call Button LED blinking at one second intervals.
The intercom can automatically answer an incoming call.
You can press the call button to terminate an active call.
Upon initial power or reset, the call button LED will illuminate.
While the software is setting up the network, the call button led will blink rapidly (10 times/
second).
When the software has finished initialization the Call Button LED will blink twice.
When a call is established (not just ringing), the Call Button LED will blink.
On the Device Configuration
sets the normal state for the call button led. The Call Button LED will still blink during
initialization and calls.
The Call Button LED will flash briefly at the beginning of RTFM mode.
Figure 2-5. Call Button and Call Button LED
Page, there is an option called
930242A-D
Installing the VoIP Intercom
Intercom Setup
Button Lit When Idle. This option
Call Button and Call Button LED
CyberData Corporation
15