Converter Housing And Oil Pump Assembly; Disassembled View; Disassembly; Inspection And Repair - Isuzu Trooper 1999 Workshop Manual

Converter Housing And Oil Pump Assembly

Disassembled View

Legend
(1) Converter Housing
(2) Outer Seal Ring
(3) Gasket

Disassembly

1. Remove oil pump assembly from converter housing.
2. Remove outer seal ring.
3. Remove gasket.
4. Remove wear plate.
5. Remove oil seal ring.

Inspection And Repair

Visual Check:
If any damage, deformation, or local wear is found in a
converter housing, outer seal ring, wear plate, or oil seal
ring, replace it.

Reassembly

1. Install wear plate onto oil pump assembly.
2. Install converter housing onto complete oil pump
assembly. Align with two short J–38588 guide pins on
outer bolt holes.
f Loosely install five 13mm bolts.
f Center converter housing using J–38557 centering
tool.
f Tighten five inner 13mm bolts in an alternating
pattern.
Torque: 20 N m (15 lb ft)
AUTOMATIC TRANSMISSION (4L30–E)
(4) Wear Plate
(5) Oil Pump Assembly
(6) Oil Seal Ring
3. Install oil seal ring (3 screws).
Torque: 3 N m (26 lb in)
4. Install gasket.
5. Install outer seal ring.
7A–59
241RW003
241RW002