WIPER/WASHER SYSTEM
8B–6
Removal
1. Push the wiper blade lock(1) while pulling the wiper
blade in the arrow direction as shown in the figure.
CAUTION: When the wiper blade has been
removed, wrap the tip of the wiper arm with cloth, to
avoid damaging the glass.
2. Pull the end of rubber and remove the projection(3)
from the click of the blade stay (2).
3. Pull the rubber out in the same direction.
Windshield Wiper Blade Rubber
880RS011
880RS010
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Install the click of the blade stay in the groove of the
new rubber and slide it in. Complete wiper blade
installation by pushing the click.
2. Finally, check that the click of the stay has caught in
the hole of the rubber.
885RS002
885RS001