Windshield Wiper Arm/Blade; Removal; Installation - Isuzu Trooper 1999 Workshop Manual

Removal

1. Pry the cap(2) off with the tip of a screwdriver.
2. Remove the nut(3).
3. Remove the wiper/blade(1).

Installation

To install, follow the removal steps in the reverse order,
noting the following points.
1. Wiper arm/blade
f Before installing the wiper arm/blade to the shaft,
confirm that the motor stops at the auto-stop
position.
f Set the wiper arm/blade so that the tips of both
blades are positioned about 35 mm (1.37 in) from
the upper edge of the cowl cover as shown in the
figure.

Windshield Wiper Arm/Blade

880RS005
880RS004
WIPER/WASHER SYSTEM
f Tighten the nuts to the specified torque.
Torque: 31 N·m (23 lb ft)
8B–5