Rivet Head Depression; Release Bearing; Wedge Collar - Isuzu Trooper 1999 Workshop Manual

Rivet Head Depression

1. Use a depth gauge or a straight edge with steel rule to
measure the rivet head depression 1 from the facing
surface 2.
2. Be sure to measure the rivet head depression on both
sides of the driven plate.
3. If the measured value is less than the specified limit,
the driven plate assembly must be replaced.
Rivet Head Depression
Standard: 1.95 mm (0.077 in)
Limit: 0.2 mm (0.008 in)

Release Bearing

1. Visually check the release bearing for excessive play,
noise and breakage.
2. If any of these conditions are discovered, the release
bearing must be replaced.
3. When replacing the release bearing, replace both the
wedge collar and wire ring at the same time.
Legend
201RS010
(1) Wire Ring
(2) Pressure Plate Assembly

(3) Wedge Collar

(4) T/M Side
(5) Release Bearing
(6) Engine Side
Wedge Collar
1. Visually check the surfaces of the wedge collar
making contact with the release bearing for excessive
wear and damage.
2. Replace any exhibiting excessive wear or damage.
201RS011
CLUTCH 7C–11
201RW010
201RS013