Manual Transmission Assembly; Removal - Isuzu Trooper 1999 Workshop Manual

MANUAL TRANSMISSION
7B–4

Removal

NOTE: Before remove the transmission and transfer
assembly from the vehicle, change the transfer mode to
2WD using push button on dash panel.
1. Remove engine hood.
2. Disconnect battery ground cable.
3. Remove the gear control lever knob.
4. Remove the front console assembly.
5. Remove the grommet assembly.
6. Remove the transmission control lever and transfer
control lever.
7. Remove transfer protector.
8. Remove the rear propeller shaft.
NOTE: Apply alignment marks on the flange at the both
front and rear side.

Manual Transmission Assembly

235RX001
401RS002
9. Remove the front propeller shaft.
NOTE: Apply alignment marks on the flange at both the
front and rear sides.
10. Disconnect the reverse lamp switch, 4WD indicator
switch, 1-2 and 3-4 indicator switch harness
connectors.
401RS003
230RW005