Sdi 2 Connector (Hdc1500); Sdi Connector (Hdc1400/1550); Build Up Connector; (Hot Shoe Assembly) - Sony HDC1000 Maintenance Manual

2-8-9. SDI 2 Connector (HDC1500)

SDI Connector (HDC1400/1550)

1. Remove the MIC panel assembly.
(Refer to Section 2-8-2.)
2. Remove the five screws, and remove the BNC assem-
bly.
3. Disconnect the harness from the connector (CN3) on
the CN-2620 board.
4. Remove the nut to detach the SDI 2/SDI connector.
CN-2620 board
CN3
BNC assembly
Nut
Washers
SDI 2/SDI
connector
5. Install a new SDI 2/SDI connector by reversing the
steps above.

2-8-10. BUILD UP Connector

(Hot Shoe Assembly)

1. Remove the inside panel and outside panel.
(Refer to Section 1-4.)
2. Remove the switching regulator.
(Refer to Section 2-11-2.)
HDC1000/V1(E)
MIC panel assembly
Screws
(M2)
Screws
(M2)
3. Disconnect the harness from the connector (CN17) on
the MB-1059 board.
4. Remove the four screws, and remove the hot shoe
assembly.
MB-1059 board
CN17
B3 x 8
5. Remove the two fixing screws of the connector and
remove the BUILD UP connector.
6. Install a new BUILD UP connector by reversing the
steps above.
Hot shoe assembly
B3 x 8
BUILD UP connector
Screw of the connector
2-17