Sony HDC1000 Maintenance Manual page 71

18. Install the MB-1060 board by reversing the steps
above.
m
. Arrange the harness, cables and flexible card wire on
the MB-1060 board (side A) as shown below, and
clamp them with the harness clamp.
CN6
CN14
CN2
CN3
CN7
CN17
CN9
Harness clamp
CN9
. Check cable numbers when connecting optical fiber
cables, and insert the cable connector as far as it will
go.
. Arrange the harness and cables on the SDI-84 board
as shown below, and clamp them with the three
harness clamps.
Coaxial cable
(green)
Harness clamp
SDI-84
board
Harness clamps
Optical fiber cable (No.1)
HDC1000/V1(E)
MB-1060 board
(side A)
CN4
Coaxial cable
CN29
CN4
(orange)
Coaxial cable
CN28
(yellow)
Optical fiber cable (No.2)
CP401
CN102
CP201
Coaxial cable (brown)
. Hold the plug of the coaxial cable, and connect it
perpendicularly to the connector.
Push the plug into the connector while turning it
clockwise and counterclockwise several times.
Hold the plug to connect
Connecting connector
. When connecting the optical fiber cables to the E/O
converter module CP201 or O/E converter module
CP401 on the SDI-84 board, clean the connecting
connectors. (Refer to Section 1-8.)
2-27