Table of Contents
Advertisement
1-17. Description of CCD Block Number
Every CCD unit has its own ID number called CCD block
number. It shows the CCD block type and serial number
for the CCD block.
The CCD block number label is put in the CCD unit.
Example : MDA xxxxx
Serial number for the CCD unit
CCD block type
Model
CCD block type
HDC1000
MDC
HDC1500
HDC1550
HDC1400
MUA
HDC1580
MPB
For replacing the CCD unit, refer to Section 2-1.
1-18. Optional Fixtures
Name
Sony Part No.
Remarks
EX-738 Board
A-8327-351-A
For extension of plug-in
boards
Extension assy,
A-8344-327-A
For extension of DPR-265
DPR-197
and SDI-84 boards.
Alignment sleeve
J-6480-010-A
For female connector
remover HC-001
LEMO® DCC.91.312.5LA
or equivalent
PLD download
J-7120-140-A
PLD data download
fixture
cable
1-19. Notes on Repair Parts
1. Safety Related Components Warning
w
Components marked ! are critical to safe operation.
Therefore, specified parts should be used in the case of
replacement.
2. Standardization of Parts
Some repair parts supplied by Sony differ from those
used for the unit. These are because of parts common-
ality and improvement.
Parts list has the present standardized repair parts.
3. Stock of Parts
Parts marked with “o” at SP (Supply Code) column of
the spare parts list may not be stocked. Therefore, the
delivery date will be delayed.
4. Harness
Harnesses with no part number are not registered as
spare parts.
1-20. Unleaded Solder
Boards requiring use of unleaded solder are printed with a
lead free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come
printed with the lead free mark due to their particular size.)
: LEAD FREE MARK
m
. Be sure to use the unleaded solder for the printed circuit
board printed with the lead free mark.
. The unleaded solder melts at a temperature about 40 dC
higher than the ordinary solder, therefore, it is recom-
mended to use the soldering iron having a temperature
regulator.
. The ordinary soldering iron can be used but the iron tip
has to be applied to the solder joint for a slightly longer
time. The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful.
1-36
Hide quick links:
Advertisement
Table of Contents
