Intercom 1/2 Connector; (Cn-2618 Board); Lens Connector (Cn-2616 Board) - Sony HDC1000 Maintenance Manual

2-8-3. INTERCOM 1/2 Connector

(CN-2618 Board)

1. Remove the six screws and pull out the INTERCOM
panel assembly.
2. Disconnect the flexible card wire from the connector
(CN1) on the SW-1273 board.
3. Remove the two screws, and remove the CN-2618
board.
4. Disconnect the harness from the connector (CN1) on
the CN-2618 board.
5. Unsolder the INTERCOM 1 or INTERCOM 2 connec-
tor from the CN-2618 board.
CN-2618 board
CN1
CN-2618 board
INTERCOM 1/2 connector
6. Install a new INTERCOM 1 or INTERCOM 2 connec-
tor by reversing the steps above.
2-14
SW-1273 board
INTERCOM
panel
CN1
assembly
CN1
Screws
(M2)
Screws
(M2)
P2.6 x 5
Screws
(M2)
Unsolder

2-8-4. LENS Connector (CN-2616 Board)

1. Remove the three screws, and pull out the front switch
cover assembly.
2. Remove the screw, and pull out the CN-2616 board.
3. Disconnect the harness from the connector (CN2) on
the CN-2616 board.
CN2
CN-2616 board
P2 x 4
Screws (M2)
Front switch cover assembly
4. Unsolder the LENS connector from the CN-2616
board.
5. Remove the nut to detach the washer and lens bracket
from the LENS connector.
LENS connector
6. Install a new LENS connector by reversing the steps
above.
CN-2616 board
Unsolder
Nut
Washer
Lens bracket
HDC1000/V1(E)