1-9. Setting the Utility Out Voltage
(HDC1000)
Set the utility out voltage in accordance with the voltage of
peripheral devices when they are connected to the camera.
The setting of the utility out voltage can be made by the
combination of the switches 1 and 2 in the figure.
100V120V
1
. When setting to 100 V, set as shown below.
100V120V
1
. When setting to 120 V, set as shown below.
100V120V
1
. When setting to 230 V, set as shown below.
Setting of the switch 1 is not required.
100V120V
230V
1
2
1-24
230V
2
230V
2
230V
2
100V120V
230V
1
2
1-10. Notes on Flexible Card Wire
1-10-1. Disconnecting/Connecting Flexible
Card Wire
The flexible card wires are used between the boards of
HDC1000/1400/1500/1550/1580. Take care not to bend
forcedly these flexible card wires. This shortens the wire life.
HDC1000
Between CN-2579 and DR-528
Between CN-2579 and PA-317
Between TG-243/243C and DR-528
Between AT-166 and SW-1233
Between MB-1060 and CN-2609
HDC1400/1500/1550/1580
Between CN-2579 and DR-528
Between CN-2579 and PA-317/317C
Between TG-243/243B/243C and DR-528
Between MB-1059 and CN-2619
Between MB-1059 and CN-2621
Between MB-1059 and SW-1273
Between MX-109 and TR-136 (HDC1550 only)
Type-A
Disconnecting
Slide portions A in the direction of the arrow to unlock and
pull out the flexible card wire.
Connecting
m
. Be careful not to insert the flexible card wire obliquely.
. Check that the conducive surface of the flexible card
wire is not soiled with dust.
1. Slide portions A in the direction of the arrow and
insert the flexible card wire with the conductive
surface downward as far as it will go.
2. Slide portions A in the reverse direction to lock.
A
A
Conductive
surface
HDC1000/V1(E)