Sony HDC1000 Maintenance Manual page 125

(For lens compatible with serial communication)
(1) Check that the lens number is No. 17.
(2) Also check that the name of the lens and minimum f-stop value.
(3) Turn on the dynamic shading.
(4) Set the lens extender to OFF.
(5) Adjust the white balance and flare balance shooting the grayscale chart.
(6) Zooming the lens, and adjust the center marker to a position at which the subject does not move.
(7) Store the Lens File.
[FILE] → [LENS|FILE] → [STORE|FILE]
(8) Set the lens extender to ON.
(9) Adjust the white balance and flare balance shooting the grayscale chart.
(10) Zooming the lens, and adjust the center marker to a position at which the subject does not move.
(11) Store the Lens File.
[FILE] → [LENS|FILE] → [STORE|FILE]
*1 : If using the lens compatible with serial communication with the dynamic shading turned on, you do
not require the V modulation adjustment. Adjust the white shading or V modulation only when the
deviation occurs. In this case, the data will not be stored in the Lens File.
*2 : The center marker position is stored in the Lens File immediately after the position is aligned and not
when executing the Lens File store.
Calling
Using OPERATION Menu of This Unit
Select the Lens File.
[OPERATION] → [LENS|FILE]
HDC1000/V1(E)
*1
*2
*2
4-9