Sony HDC1000 Maintenance Manual page 70

9. Loosen the two screws with stopper.
n
There is the model for which the normal screws
(PSW3 x 6) are used, too.
10. Remove the four screws, and remove the SDI unit
assembly.
11. Disconnect the coaxial cable from the connector
(CN601) on the DPR-265 board.
CN601
DPR-265 board
12. Disconnect the harness from the connectors (CN10,
CN11, CN13, CN15, CN16, and CN27) on the MB-
1060 board (side B).
CN16
CN15
CN10
CN13
MB-1060 board
(side B)
2-26
B3 x 10
Screws with
stopper/
PSW3 x 6
SDI unit
assembly
PSW3 x 6
Coaxial cable (red)
CN27
CN11
13. Release the harness from the harness clamp.
14. Disconnect the harness and flexible card wire from the
connectors (CN2, CN3, CN6, CN7, CN14, and CN17)
on the MB-1060 board (side A).
CN7
CN2
CN3
CN17
Harness clamp
15. Remove the six screws, and remove the MB-1060
board.
16. Disconnect the harness from the connectors (CN4,
CN9) on the MB-1060 board.
17. Disconnect the coaxial cables from the connectors
(CN28, CN29) on the MB-1060 board.
Coaxial cable
(orange)
CN29
Coaxial cable
CN28
(yellow)
CN6
CN14
MB-1060 board
(side A)
MB-1060 board
PSW3 x 6
CN9
CN4
CN29
CN28
HDC1000/V1(E)