1-4. Opening/Closing the Side Panel
HDC1000
1. Unscrew the two lock screws of the side panel.
2. While sliding the safety lock toward the lens, open the
side panel by holding the handle.
3. Close the side panel and tighten securely the lock
screws of the side panel.
n
Closing the side panel brings the safety lock to an
automatic locking.
HDC1400/1500/1580
1. Unscrew the nine screws as shown in the figure, then
open the inside panel and outside panel.
2. Release the hanging band (FRONT) and hanging band
(REAR) from the inside panel.
3. Disconnect the harness from the connector (CN1) on
the SW-1240 board, and remove the inside panel.
4. Disconnect the harness from the switching regulator
connector, and remove the outside panel.
Outside panel
Screws
Hanging Band
(FRONT)
SW-1240 board
5. Reinstall the panels by reversing the steps above.
1-14
Safety lock
Handle
Lock screws of the side panel
Switching regulator
Hanging Band
(REAR)
CN1
Screws
Inside panel
HDC1550
1. Unscrew the nine screws as shown in the figure, then
open the inside panel and outside panel.
2. Release the hanging band (FRONT) and hanging band
(REAR) from the inside panel.
3. Disconnect the harness from the connector (CN1) on
the SW-1240 board, and remove the inside panel.
4. Disconnect the harness from the connector (CN3) on
the FL-337 board, and remove the outside panel.
Outside panel
FL-337 board
Screws
Hanging Band
(FRONT)
SW-1240 board
5. Reinstall the panels by reversing the steps above.
Switching regulator
CN3
Hanging Band
(REAR)
CN1
Screws
Inside panel
HDC1000/V1(E)