Setting The Voltage Warning Values; Magnifying The Image Display; Monitoring High Key Blown-Out Highlights And Low Key Clipped Blacks - Sony F65 Operation Manual

Item Setting
Horizontal Specifies the horizontal position in
relation to the center position (-958 to
958).
Vertical Specifies the vertical position in relation
to the center position (-538 to 538).
Width Specifies the width (320 to 1920) of the
box cursor.
Height Specifies the height (180 to 1080) of the
box cursor.
3-7-3 Setting the Voltage Warning
Values
The Near End and End values used to issue battery voltage
warnings when the supply voltage drops are set on the
<Battery Alarm> page in the Config menu.
Two Near End and End values can be saved, and you can
switch between them as required.
<Battery Alarm> page
Item Setting
DC IN (24V) Type Selects the 24 V system supply settings.
You can set Near End and End
threshold values for both Type1 and
Type2.
Near End Sets the 24 V power supply Near End
value (20.5 V to 30.0 V). The default is
22.2 V.
End Sets the 24 V power supply End value
(20.0 V to 24.0 V). The default is 21.6 V.
DC IN (12V) Type Selects the 12 V system supply settings.
You can set Near End and End
threshold values for both Type1 and
Type2.
Near End Sets the 12 V power supply Near End
value (11.0 V to 17.0 V). The default is
11.1 V.
End Sets the 12 V power supply End value
(10.5 V to 14.0 V). The default is 10.8 V.
46
Viewing and Setting the Viewfinder Display

3-7-4 Magnifying the Image Display

The image output on the SDI OUT2 connector and in the
viewfinder can be magnified by assigning the Mag
function to an ASSIGN button.
Type" setting on the <Mag> page of the Config menu, the
magnification changes between 2-times, 4-times, and Off
each time the ASSIGN button is pressed.
The position of the magnified image can be adjusted by
assigning the Mag Position function to another ASSIGN
button. The position of the magnified image moves one
step from top left to bottom right each time the ASSIGN
button is pressed.
1) The signal output in the viewfinder is active only when SDI OUT2 is
selected as the signal source.
Notes
• The Mag function can only be used for the image output
from the SDI OUT2 connector.
• The Mag function cannot be used during Rec Review in
HD mode or when Frame Rate is set to a "ForPB" setting
in F65RAW-HFR mode.
• When "Auto Off Timer" on the <Mag> page of the
Config menu is set to On, the magnified display returns
to normal 30 seconds after pressing the ASSIGN button.
Also, the display returns to normal when power is
applied and when recording starts.
When the image is magnified, the following information is
displayed in the viewfinder.
a Magnification
When the image is magnified by 2, "Mag x 2" is displayed;
when magnified by 4, "Mag x 4" is displayed.
b Magnification position
Displays the position of the magnified image.
3-7-5 Monitoring High Key Blown-
out Highlights and Low Key Clipped
Blacks
Blown-out highlights and clipped blacks in the output
image on the SDI OUT2 connector can be monitored using
an ASSIGN button assigned with the Hi/Lo Key function.
1)
Depending on the "Mag
2
1