Honda EP3 Service Manual page 94

1 8 .
1 9 .
Remove the drive belt (see page 4-26).
R e m o v e t h e l v C l i n e m o u n t i n g b o l t .
20. Remove the radiator cap.
2 1 . R a i s e t h e h o i s t t o f u l l h e i g h t .
22. Remove the front tires/wheels.
23. Remove the splash shield.
o@
2 4 . L o o s e n t h e d r a i n p l u g i n t h e r a d i a t o r t o d r a i n t h e
engine coolant (see page 10-6).
2 5 . D r a i n t h e t r a n s m i s s i o n f l u i d ( s e e p a g e 1 3 ' 3 ) .
26. Drain the engine oil {see page 8-5).
2 7 . D i s c o n n e c t t h e s t a b i l i z e r l i n k s ( s e e p a g e 1 8 - 1 8 ) .
28. Disconnect the suspension lower arm ball joints
( s e e s t e p 3 o n p a g e 1 8 - 1 9 ) .
29. Remove the driveshafts {see page 16-3). Coat all
p r e c i s i o n f i n i s h e d s u r f a c e s w i t h c l e a n e n g i n e o i l .
Tie plastic bags over the driveshaft ends.
30. Disconnect the air fuel ratio {4,/F) sensor connector
(A) and secondary heated oxygen sensor
(secondary HO2S) connector (B), then remove the
three way catalytic converter {TWC) assembly {C).
3 1 . R e m o v e t h e l o w e r h o s e .
(cont'd)
5-5