Recall Timer Duration - Avaya Partner Administration Manual

5. System Changes

5.1 Recall Timer Duration

Use this feature to change the length of the timed signal or switch hook flash, generated by the system Recall feature (as
well as by the Recall option used in Auto Dial and Speed Dial numbers). Recall sends this timed signal over the telephone
line to the local telephone company or PBX to which the system is connected. Typically, you use the Recall feature to
access a PBX, central office or Centrex feature, such as Call Waiting. Your local telephone company can tell you the
correct setting—for most Centrex systems, the correct setting is 800 milliseconds.
You should change the default setting only under two conditions:
· If using the system Recall feature has no effect, lengthen the time.
· If the system is connected to a PBX and Recall drops calls, shorten the time.
To change the duration of the recall signal (ETR 18D/34D)
1. At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2. Dial #107. The phone will display Recall Timer Duration.
3. Enter two digits between 01 and 80. 01 is 25 milliseconds and 80 is 2000 milliseconds. Each number from 01 to 80
increases the timer by 25 milliseconds. Upon entry of the 2nd digit, the recall timer is updated.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change the duration of the recall signal (1408/1416 Phone)
1. At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2. Use the up or down
Select.
3. Use the up or down
Select.
· Alternatively, dial # and the same code as used by ETR phones for
4. Use the up or down
5. The current setting is displayed.
6. Enter then option required between 01 and 80. Each step increases the timer by 25 milliseconds. Alternatively use
the left or right
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
PARTNER Phone Administration
IP Office PARTNER Version
arrow buttons to scroll the display to System Administration. When displayed, press
arrow buttons to scroll the display to System Parameters. When displayed, press
arrow buttons to scroll the display to Recall timer. When displayed, press Select.
arrow icons to toggle the settings or Default to return to the default setting (20 500msec).
system administration
7
- Issue 1b (22 February 2010)
.
Page 46