Table of Contents
Advertisement
The tiptel.com 822XT rack a 19 inch rack unit designed for installation in 19 inch ca-
binets. The system is two units in height. During assembly, ensure that there is ade-
quate air circulation.
Tools required
•
Percussion drill with 6 mm masonry bit
•
Various screwdriver sizes
•
Side-cutting nipper, strip-insulation pliers, crimping pliers for US-type phone
plugs where applicable
Assembly order
The following sequence must be observed when installing the system:
•
Determine the ISDN wiring variants and appropriate cable
•
Wire the junction boxes
•
Installation location requirements
•
Wall mounting of the unit
•
Check and, where applicable, change the jumper settings
•
Connect the terminals
•
Connect the system to the NTBA and ADSL modem
•
Connect the system to the 230 Volts mains network
First start-up
17
Advertisement
Table of Contents
