Static Routing - 3Com OfficeConnect User Manual

To set up One-to-One NAT:
Select One-to-One NAT from the NAT Mode drop-down box.
1
2 Enter the second address of your Internet range of addresses in
the First IP Address in ISP Pool field.
3 Enter the first address in your LAN range of addresses to which
you want to map this range in the First IP Address in LAN Pool
field.
3Com recommends that you set your DHCP pool to the same as
the range of LAN addresses used as your LAN pool.
4 Enter the number of addresses in the range into the Pool Size
field.
Click Apply to save your changes.
5

Static Routing

Setting up Static Routing
The Router supports up to 10 static routes in total, shared
between LAN and WAN interfaces. WAN side static routes are
only available if the mode of connection to your ISP is Static or
Dynamic (DHCP Client mode).
To set up Static Routing:
Select New on the right side of the screen to open the Static
1
Routing configuration dialogue box.
2 Enter the IP address of the Destination Network (e.g.
192.168.20.0).
3 Enter the IP address of the Subnet Mask (e.g. 255.255.255.0).
Enter the IP address of the Gateway Address (e.g. 192.168.1.25).
4
5 Select the location of the Destination Network in relation to the
Router (either LAN or WAN) from the Location drop down box.
Click Apply to save your changes.
6
The list of all routes (static and dynamic) are listed in the Status
and Logs section.
Figure 41 Static Routing Screen
46