Fitting Vigo Connect In Genie; Nearcom - oticon Vigo Connect Fittings Manual

Fitting Vigo Connect in Genie

nEARcom

For greater flexibility and comfort use nEARcom without
cables to fit Vigo Connect instruments.
To prepare Genie for nEARcom, see the nEARcom Quick
Guide.
8 VIGO CONNECT FIT TING GUIDE
Detect the instruments
1. Insert fresh batteries into the instruments and switch
on the instruments.
2. Lay nEARcom on the table and place the instruments
in the middle of the neck loop.
3. Click Detect for cordless programming.
Cordless programming
Wired programming
Instruments which have never been programmed must be
assigned to the correct side – left and right – in Genie.
Use a BEEP test as follows:
1
To identify the instrument keep it in the middle of the
neck loop and click BEEP. The instrument will beep for
6 seconds.
While the instrument is beeping, remove it from
nEARcom and listen to it.
If the instrument does not beep, return it to the middle of the
1
neck loop, click the Change side icon and click the same
BEEP. Listen to the instrument again.
Click Continue and proceed with the fitting.
9