Other Tools - oticon Vigo Connect Fittings Manual

Other Tools

18 VIGO CONNECT FIT TING GUIDE
Acoustics:
Use the Acoustics tool to change vent size or dome type.
Feedback Manager:
This is a fast and effective way to set the instrument's
feedback limits to ensure that no static feedback is present,
2
however the introduction of DFC makes this almost unnec-
essary.
If feedback occurs, run the FBM from P1. The feedback limits
will be applied to all programs in the hearing instrument.
Note: It is not possible to adjust the controls above the new
feedback limit. Gain limits applied to the control setting
2
depend on whether the DFC system is active or not.
This means that gain can be increased more when the DFC
is enabled.
All Vigo Connect instruments have Dynamic Feedback Cancel-
2
lation that contributes to the instruments' superb sound
quality.
Identity Selector:
In the Identity Selector you can change between the different
identities. If any fine tuning has been done in the current
Genie session, it is also possible to change between fine
tuned and prescribed identities.
Note: Identities and the Identity Selector are only available
for the NAL-NL1 rationale.
2
19