Attaching The Slide-Rail Assemblies To The Rack; Attaching Bolt-On Slide-Rail Assemblies - Sun Microsystems Sun Fire X4450 Installation Manual

3. Verify that the rear locating pin has engaged the mounting-bracket clip.
See
4. Repeat to install the remaining mounting-bracket on the other side of the
server.
Attaching the Slide-Rail Assemblies to
the Rack
Do one of the following procedures to attach the slide-rail assemblies to the rack:
"Disassembling Bolt-On Slide-Rails" on page 11
■
"Disassembling Tool-less Slide-Rails" on page 12
■

Attaching Bolt-On Slide-Rail Assemblies

To attach bolt-on slide-rail assemblies to the rack:
1. Position a slide-rail assembly in your rack so that the brackets at each end of
the slide-rail assembly are on the outside of the front and rear rack posts. (See
FIGURE 2-3
2. Attach the slide-rail assembly to the rack posts, but do not tighten the screws
completely.
Choose one of the following methods to attach the slide-rails. The method you
use varies, depending on the type of rack:
■
■
14 Sun Fire X4450 Server Installation Guide • July 2008
.
FIGURE 2-2
.)
If your rack has threaded mounting holes in the rack posts, first determine
whether the threads are metric or standard, then insert the correct mounting
screws through the slide-rail brackets and into the threaded holes.
If your rack does not have threaded mounting holes, insert the mounting
screws through both the slide-rail brackets and rack posts, then secure them
with the caged nuts.