Installing the Cable Management Arm
Use this procedure to install an optional cable management arm (CMA).
shows the CMA.
FIGURE 2-7
1. Unpack the cable management arm parts.
2. Take the CMA to the back of the equipment rack and ensure that you have
adequate room to work around the back of the server.
Note – References to "left" or "right" in this procedure assume that you are facing
the back of the equipment rack.
3. Remove tape to separate parts.
The CMA rail extension might be taped to the CMA arm.
4. Attach the CMA rail extension into the left slide-rail until the extension locks
into place with an audible click. (See
20
Sun Fire X4450 Server Installation Guide • July 2008
Cable Management Arm (CMA)
CMA rail
extension
.)
FIGURE 2-8
FIGURE 2-7