Installation Worksheet - Sun Microsystems Sun Fire X4450 Installation Manual

Installation Worksheet

Fill in
OS for the server. Collect only the information that applies to your system.
Installation Worksheet
TABLE 4-1
Installation Information
Language
Locale
Terminal
Network connection
DHCP
If you are not IP address
using DHCP,
note the network
address.
Subnet
IPv6
Host name
Kerberos
with information you need to configure the preinstalled Solaris 10
TABLE 4-1
Description
Choose from the list of available languages
for the Solaris 10 software.
Choose your geographic region from the list
of available locales.
Choose the type of terminal that you are
using from the list of available terminal
types.
Is the system connected to a network?
Can the system use Dynamic Host
Configuration Protocol (DHCP) to configure
its network interfaces?
If you are not using DHCP, supply the IP
address for the system.
Example: 129.200.9.1
If you are not using DHCP, is the system
part of a subnet?
If yes, what is the netmask of the subnet?
Example: 255.255.0.0
Do you want to enable IPv6 on this
machine?
A host name that you choose for the system.
Do you want to configure Kerberos security
on this machine?
If yes, gather the following information:
Default Realm:
Administration Server:
First KDC:
(Optional) Additional KDCs:
Chapter 4 Configuring the Preinstalled Solaris 10 Operating System
Enter System Configuration:
Asterisk (*) indicates default.
English*
English
(C - 7-bit ASCII)*
Networked
Non-networked*
Yes
No*
255.255.0.0 *
Yes
No*
Yes
No*
45