Method 3: Using The Service Processor (Sp) Lom Web Browser Interface - Sun Microsystems Sun Fire X4450 Installation Manual

7. Type the following command to change a static address to a DHCP address:
ELOM:
set /SP/network IPSource=dhcp
ILOM:
set /SP/network pendingipdiscovery = dhcp
set /SP/networks/
8. Type show /SP/network to view the newly assigned DHCP address.
DHCP enabled is shown as ipdiscovery=DHCP
Method 3: Using the Service Processor (SP) LOM
Web Browser Interface
Note – The SP web Browser Interface can be accessed only if you know the SP IP
address. See
To change a static IP address, using the SP LOM web interface:
1. Open a Sun Microsystems supported Web browser, such as Internet Explorer,
Mozilla, or Firefox.
2. Type the IP address of the SP in the browser address bar.
For example: http://xxx.xxx.xxx.xxx
3. Accept the certificate when prompted.
4. Enter your username (root) and password (changme).
5. Select the Configuration tab and then the Network tab.
6. Set configurations, such as IP configuration and DNS, as required.
7. Do one of the following:
■
■
8. If you manually change the IP address, you must manually change the subnet
mask, because the subnet mask changes according to the IP address class.
9. Record your settings.
10. Log out.
40 Sun Fire X4450 Server Installation Guide • July 2008
"Determining the LOM Service Processor IP Address" on page
If DHCP is required, select the Enable DHCP check box.
If STATIC is required, clear the Enable DHCP check box, and manually set all
IP information.
commitpending=true
34.