Table of Contents
Advertisement
Installing the Switch in the Rack
The procedure for installing the switch in a full rack while bringing the power cord across along
side of the switch can be found in the switch user manual.
The switch platform can be rack mounted and is designed for installation in a standard 19" rack.
The power side of the switch includes a hot-swap power supply module, a blank cover for an
optional second PSU for redundancy, and a hot-swap fan tray. There are two possible air flow
directions. Be sure that the switch air flow direction is compatible with your system, rack, and
PSUs. The connector side of the switch has the QSFP ports, system LEDs, and management con-
nection ports.
The switch platform contains auto-sensing 100 - 240 VAC connections for all possible PSUs.
The installer should use a rack capable of supporting the mechanical and environmental charac-
teristics of a fully populated platform.
The rack mounting holes conform to the EIA-310 standard for 19-inch racks.
Take precautions to guarantee proper ventilation in order to maintain good air-
flow at ambient temperature. Cable routing in particular should not impede the
air exhaust from the chassis.
Minimum and Maximum Rack Depth for this Switch
This switch can be installed in any standard 19"racks with depths of 380mm to 800mm.
The short switch with the MIS000079 Rail kit can only go into a 19" rack whose vertical sup-
ports are between 380mm and 500mm apart.
To use the IS50XX in a rack deeper than 500mm, order the IS50XX with the
standard depth, or order the MIS000083 rail kit. The both of these solutions will
allow you to install the switch in a 19" rack whose vertical supports are between
500mm and 800mm apart.
The standard depth switch uses the MIS000085 rail kit for installation in a 19" rack whose verti-
cal supports are between 500mm and 800mm apart.
Mellanox Technologies
Rev 1.8
11
Hide quick links:
Advertisement
Table of Contents
