Grounding The Switch - Mellanox Technologies MIS5025 Installation Manual

36 port infiniband qdr switch platform
Table of Contents

Advertisement

Grounding the Switch

Check to determine if your local or national electrical codes require an external ground to all IT
components. If so, connect a ground wire to one of the casing screws and connect the other end to
a valid ground. If you choose to not use the ground screw, make sure that the rack is properly
grounded and that there is a valid ground connection between the chassis of the switch and the
rack. Test the ground using an Ohm meter.
Some national and/or local codes may require IT components to be bonded and exter-
nally grounded (not including the power cord ground). You must follow all national and
local codes when installing this equipment.
Mellanox Technologies
Rev 1.8
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mis5030Mis5035

Table of Contents