Table of Contents
Advertisement
Rev 1.8
Table 7 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 2)
Wizard Session Display (Example)
Step 5: Admin password (Press <Enter> to leave
unchanged)? <new_password>
Step 6: Confirm admin password?
<new_password>
You have entered the following information:
1.
Hostname: <switch name>
2.
Use DHCP on mgmt0 interface: yes
3.
Enable IPv6: yes
4.
Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: no
5.
Admin password (Enter to leave unchanged):
(CHANGED)
To change an answer, enter the step number to
return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the
"configuration jump-start" command from con-
figuration mode. Launching CLI...
<switch name> [>
22
Mellanox Technologies
Comments
To avoid illegal access to the machine, please
type a password and then press <Enter>. Then
confirm the password by re-entering it.
Note that password characters are not printed.
The wizard displays a summary of your choices
and then asks you to confirm the choices or to re-
edit them.
Either press <Enter> to save changes and exit, or
enter the configuration step number that you wish
to return to.
Note:
To run the command "configuration jump-start"
you must be in Config mode.
Hide quick links:
Advertisement
Table of Contents
