Installing The Switch In The Rack; Table Top Installation; Figure 7: Placing The Bumpers - Mellanox Technologies MIS5022Q-1BRR User Manual

Rev 1.2
5.2

Installing the Switch in the Rack

This installation kit can only be used to install this switch.
Tools and Parts
Tools required and customer supplied parts
• Phillips Screwdrivers #1 and #2
• ESD Strap
• ESD mat
The following procedure can be done by one person.

5.2.1 Table Top Installation

1. Peel and stick the four rubber bumpers into the bottom of the switch. Place them in the round
circles.
Bottom of the switch
2. Place on a flat surface. Make sure the switch is sits solid on the surface.
3. Connect the power cord.
22
Mellanox Technologies
• Grounding screw
• Grounding wire sufficient to reach a valid ground

Figure 7: Placing the Bumpers

Installation