Table of Contents
Advertisement
Icon + Depth
17.10.4
A-Scope
Shows the real time display of the echo from the bottom.
17.11 TRANSDUCER SETUP
This menu allows you to calibrate the speed through the water, water temperature and the
keel/prop offset of the transducer.
17.11.0
Keel Offset
The keel offset can be set to cause the Fish Finder to display an offset depth below the keel
or the actual water depth from the surface. To setup to show the depth below the keel, enter
a negative depth value or a positive depth to show offset from the transducers face to the
water surface.
17.11.1
Calibrate Water Speed
Used to calibrate the Water Speed readings from the transducer. Adjustment can be made
from -10% to +10%.
17.11.2
Calibrate Water Temp
Used to calibration on the Water Temperature sensor in the transducer.
17.11.3
Set Defaults
Restores the factory settings.
17.12 ALARMS
The Alarms menu allows you to define alarm settings for Shallow Alarm, Depth Alarm and
Temperature Upper/Lower/Rate.
CP190i and CPF190i
: shown as Fish icons and their relative depth values (shown accord-
ingly to currently selected depth unit)
Figure 17.11 - Transducer Setup menu
Page 135
Advertisement
Table of Contents
