Table of Contents
Advertisement
7.
CREATING MARKS
Definitions:
MARK
Can be a stand alone position or be linked to a Route. A Mark is place on the Chart Page
using [MARK] or by entering in information in the MARK/WAYPONTS menu and selecting
NEW MARK.
WAYPOINTS
Always linked to a Route. Are placed on the Chart page using [ROUTE].
The difference between a Mark and a Waypoint is
a. When a Route is created using WAYPOINTS and the ROUTE is deleted the WAYPOINTs are
also deleted.
b. If a Route is created using MARKS and the ROUTE is deleted the MARKs remain.
7.0
CREATING A NEW MARK USING THE CHART PAGE
1. Move the ShuttlePoint knob to the desired or approx. Lat/Lon and press [MARK].
2. You will notice a Mark is placed under the location of the Cursor and a popup window
is shown with the exact Lat/Lon of the Mark.
3. If the position is incorrect press [ENT], select EDIT using the ShuttlePoint knob and
press [ENT]: it will allow you to change the position, Mark name and icon type. Refer
to Par. 7.1 for details.
1
Mark placed under Cursor
Lat/Lon of Mark, DST/BRG
2
from vessel location
Press [ENT] to delete, to move,
3
to edit a Mark or to show the
Marks/Waypoint List (Directory)
4
Vessel location
After entering in all the Marks it is a good practice to back up the points to an User C-CARD. Refer
to Section 11.
7.1
EDITING A MARK
If a Mark has previously been created and you wish to Edit it, move Cursor over the top of
the Mark.
1. After a Mark is created press [ENT], move the ShuttlePoint knob to highlight EDIT and
press [ENT].
CP190i and CPF190i
NOTE
4
1
Figure 7.0 - Mark creation
NOTE
2
3
Page 65
Advertisement
Table of Contents
