Standard Horizon CP190i Owner's Manual page 21

2.4.1.1 Connection of the FF525, AIS Receiver, VHF and Autopilot
Optional WAAS
GPS Antenna
CP190i
Optional WAAS
GPS Antenna
CP190i
Port2 Input and Output is used by the optional FF525. In the diagram above you will notice Port2
Input and Output wires are shown in gray and not used.
2.4.1.2 AIS Setup
The CP190i has to be set up to be able to receive NMEA information from the AIS receiver.
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5 for AIS Class
A and type 18, 19, 24 for AIS Class B. Select the used port and transmission speed by
following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
If an AIS receiver is not connected, Port1 Input can be connected to most DSC VHF's for position
polling.
Page 22
Red
Switch
Black
2A
Fuse
Green NMEA Common
Blue Port 1 Input
Brown Port 1 Output
Gray Port 2 Input
White Port 2 Output
Yellow Port 3 Output
PWR & ACC 1 Cable
Tee
Red
Black
Optional
Fish Finder Green
Blue
Brown
Gray
White
Transducer
Yellow
PWR & ACC 1 Cable
NOTE
NOTE
-
+
Battery
10-35Vdc
VHF
AIS
Switch
-
+
2A
Battery
Fuse
10-35Vdc
NMEA Common
AIS
Port 1 Input
Port 1 Output
Port 2 Input
Port 2 Output
Port 3 Output
CP190i and CPF190i
PILOT
VHF