Standard Horizon CP190i Owner's Manual page 23

2.4.3.1 Connection of the AIS Receiver, VHF and Autopilot
Optional WAAS GPS
antenna
CPF190i
Transducer
Optional WAAS GPS
antenna
CPF190i
Transducer
2.4.3.2 AIS Setup
The CP390i has to be set up to be able to receive NMEA information from the AIS receiver.
The GPS Chart Plotter reads the AIS NMEA message VMD, type 1, 2, 3 and 5. Select the
used port and transmission speed by following the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight IN/OUT CONNECTIONS and press [ENT] or
move the ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight PORT1 INPUT and press [ENT] or move the
ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob up/down to select AIS 38400 and press [ENT] or move the
ShuttlePoint knob to the right.
If an AIS receiver is not connected, Port1 Input can be connected to most DSC VHF's for position polling.
The Input and Output baud rate for each port is set using the Advanced Setup>In/Out Connections
menu. For example if Port1 is set for AIS 38400, the Input and Output both operate at 38400 baud.
Page 24
Red
Black
Green
Blue
Yellow
PWR & ACC 1 Cable
Red
Switch
Black
2A
Fuse
Green NMEA Common
Blue Port 1 Input
Brown Port 1 Output
Yellow Port 3 Output
PWR & ACC 1 Cable
NOTE
NOTE
Switch
-
+
2A
Battery
Fuse
10-35Vdc
NMEA Common
AIS
Port 1 Input
Port 3 Output
-
+
Battery
10-35Vdc
VHF
CP190i and CPF190i
VHF
PILOT