Table of Contents
Advertisement
PLACE NAMES SIZE standard
To activate this function follow the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight PLACE NAMES SIZE and press [ENT] or move
the ShuttlePoint knob to the right.
4. The menu now shows three selections, STANDARD, MEDIUM or LARGE.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left a few times.
6.0.3
Perspective View
The Chart page may be show in a perspective (fly over) or normal mode during navigation.
Perspective view of the chart is a type of "bird's eye" view of a chart, and give you a more
realistic perspective of the chart. As the upper side of the chart is more compressed than
the lower side, a wider chart area is visible, so it allows showing more chart information
immediately ahead and around the cursor.
Perspective View ON
To activate this function follow the procedure:
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight PERSPECTIVE VIEW and press [ENT] or
move the ShuttlePoint knob to the right.
4. The menu now shows two selections, ON or OFF.
5. Move the ShuttlePoint knob to select the selection and press [ENT].
6. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint
knob to the left until the Chart Page is shown.
CP190i and CPF190i
PLACE NAMES SIZE medium
Figure 6.0.2 - Place Names Size
Figure 6.0.3 - Perspective View
PLACE NAMES SIZE large
Perspective View OFF
Page 57
Advertisement
Table of Contents
