Table of Contents
Advertisement
The Time Setup menu allows you to enter a time zone offset for your location, selection to
automatically adjust the time for daylight savings and to configure the time in 12 or 24 hour
formats.
By setting the time in the steps below, the time shown on the Celestial page is automatically set up.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight TIME SETUP and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight TIME ZONE and press [ENT] or move the
ShuttlePoint knob to the right.
5. Look at the table and find the time zone for your area. Move the ShuttlePoint knob up
or down to select the desired zone and press [ENT].
6. Next move the ShuttlePoint knob to highlight DAYLIGHT SAVING and press [ENT] or
move the ShuttlePoint knob to the right.
7. Daylight Saving menu has 3 options:
7.1 OFF
Select Off when your location does not recognize Daylight Savings Time;
7.2 ON
Select On to manually turn Daylight Savings Time On. This is the default
selection;
7.3 AUTO
When selected the Daylight Savings Time offset is automatically changed.
8. Press [CLR] or move the ShuttlePoint knob to the left until the Chart Page is shown.
3.3
SELECTING LORAN TD OR OTHER COORDINATE SYSTEM
The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TDs or UTM.
Below is the window that will appear when customizing the Coordinate System.
CP190i and CPF190i
Figure 3.2a - Time Setup menu
NOTE
CHART DATUM
CHART ORIENTATION RES
Figure 3.3 - Coordinate System menu
Page 35
Advertisement
Table of Contents
