Changing The Name Of A Route; Creating An Olympic Route - Standard Horizon CP190i Owner's Manual

At this point the Route is saved as ROUTE01. If you would like to save the Route under a specific
name follow the next steps.
9.1

CHANGING THE NAME OF A ROUTE

To name the Route:
1. Press [MENU], move the ShuttlePoint knob to highlight USER POINTS and press
[ENT].
2. Move the ShuttlePoint knob to highlight ROUTE and press [ENT].
3. Move the ShuttlePoint knob to highlight EDIT ROUTE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight NAME and press [ENT]. A popup window will
be shown.
5. Move the ShuttlePoint knob up/down to change the characters and left/right to select
a different character in the Route's Name.
6. When finished press [ENT] to save.
7. Press [CLR] to show the Chart Page.
9.2

CREATING AN OLYMPIC ROUTE

This feature allows the starting point in a Route to be saved as the final destination point.
1. On the Chart page move the ShuttlePoint knob to the Lat/Lon of the Starting Waypoint
in the Route.
2. Press [ROUTE], the Starting Waypoint will be placed under the cursor.
3. Move the ShuttlePoint knob to the second Lat/Lon of the next leg in the Route.
4. Press [ROUTE]. Another Waypoint is shown under the cursor and a line joins the
Starting Waypoint to the second Waypoint.
5. Repeat steps 3 and 4 until all Waypoints are entered into the Route.
Page 74
NOTE
EDIT ROUTE
Figure 9.1 - Edit Route (Route Report)
CP190i and CPF190i