Table of Contents
Advertisement
1. Turn Off the GPS Chart Plotter.
2. Insert the Chart Update Card into the slot.
3. Press and hold [PWR] to turn the GPS Chart Plotter On.
4. The GPS Chart Plotter's display will show a message that the Built-In Charts are being
uploaded.
5. After uploading the GPS Chart Plotter will check to ensure the charts have been loaded
correctly and show a message.
If the message shows the charts were not updated correctly, follow steps 1-4 again. If the GPS
Chart Plotter shows a error message again, contact C-MAP USA at (800) 424-2627 for assistance.
5.1
INSERTING THE OPTIONAL MAX C-CARD
Hold the C-CARD by the long inclined side so that you can see the C-MAP B
Open the door, gently push the C-CARD into the slot: push the C-CARD in as far as it will
go, then close the door.
The small connector below the C-CARD is only used by Standard Horizon repair technicians.
Page 52
NOTE
Figure 5.1 - Inserting C-CARD
t e
co de da
se r . n se r . n
cl a ss
Figure 5.1a - Inserting C-CARD (details)
NOTE
J
Y
EPPESEN
t e
co de da
se r . n se r . n
cl a ss
CP190i and CPF190i
label.
Advertisement
Table of Contents
