Providing User Training - Simrad AP35 Instruction Manual

• If a Non-Follow Up lever (or handheld remote) is connected, test the
• Set waypoints into each navigator connected to the system, and verify
• Provide the owner with user training.

4.35 Providing user training

The user should be instructed in the "basic" operational functions, such as:
• Turning the system on and off
• Explain how to change modes (explain briefly what takes place in the
• Regaining manual control from any mode. Point out in what modes the
• How to take command at an "inactive" station if applicable.
• Lock mode and how to lock/unlock and how to shut the system down
• Show NFU and FU steering and show the difference.
• Review how to use a NFU controller if connected.
• Course change by rotary knob and buttons.
• Go through the user SETUP menu and show how to (and why) change
• Also include Nav. source, Pos. source and Compass sensor selection if
• Show the owner where the compass (or compasses) is mounted and
• Show where the Mains circuit breaker is.
22083083H
mode switching and verify Port and Stbd steering commands of the lever.
that the AP35 steers in NAV mode for each NAV source.
different modes).
helm is engaged by the autopilot (bypass/clutch).
from a locked control unit if applicable.
the settings.
applicable.
instruct him to keep magnetic items away.
Installation
89