R3000X Remote Control; S35 Nfu Steering Lever - Simrad AP35 Instruction Manual

Simrad AP35 Autopilot

2.7 R3000X Remote Control

SIMRAD
STBY-AUTO
Simrad R3000X

2.8 S35 NFU Steering Lever

STBY:
AUTO/WORK:
NAV:
Note !
NAV and WORK mode can only be entered from a control unit.
18
Push buttons for Port and
Stbd NFU commands
STBY/AUTO mode button.
AUTO, WORK or NAV
mode is when lamp is lit
The rudder will move as long as the lever is offset to Port
or Stbd (NFU steering). The mode button is lit each time
the lever is offset.
The set course will be changed by 3°/sec. when the lever
is offset to port or Stbd.
The mode button remains lit as long as the autopilot is in
AUTO or WORK mode (and NAV mode).
Mode change sequence is as follows:
AU TO
WORK
Operation of mode button returns the autopilot to initial
mode.
It is not possible to change set course by the lever.
Pressing the mode button brings the autopilot to Stby
mode, but next press brings it to Auto mode, not back to
Nav mode.
NAV
Note!
When in AUTO/WORK mode, pressing
the buttons will change the set course
1° per push. If you keep the button
pressed, it will automatically change
the course in increments of 3°/second.
Operation of mode button returns the
autopilot to initial mode except when in
Nav mode:
→ →
AUTO STBY AUTO
→ →
WORK STBY WORK
→ →
NAV STBY AUTO
Nav and Work modes can only be
entered from the control unit.
ST BY
STB Y
STBY
A UTO
WO RK
AUTO
22083083H