On/Off - Standby Mode - Simrad AP35 Instruction Manual

Simrad AP35 Autopilot
A group of user adjustable settings are provided in the AP35 USER SETUP
MENU (page 27). The settings allows adjustment of display visibility,
selection of heading sensors, navigation and position sources and the ability
to select between automatic or manual adjustable sea state filter.
Alarms are presented in plain text to alert you of system and external data
failure conditions. Alarms include both audible and visual presentations. The
alarm listing is on page 93.

2.2 ON/OFF - Standby mode

A single press on the STBY button switches the system ON and the
following status displays are shown:
SW and HW revisions shown are examples only
After approx. 5 seconds the system is operative and the unit that was turned
on will show the STBY mode Primary Display. Other units in a multistation
system will display "Inactive". Control can be available at any unit by
pressing the STBY button.
A long press (2-3 sec.) on the STBY button switches the system OFF.
Note !
In an emergency it is possible on a multistation system to turn OFF the
system at any control unit by pressing down the STBY button for 2-3
seconds.
STBY mode is also the mode that is used when steering the boat manually.
First Press
Second Press
16
* Robertson *
* AP35 *
SW V1R4
HW rev. 0
* Robertson *
* J300X *
SW V1R8
P00 M00 S000
Power board revision
S
5 sec.
STBY
HI
OFF
S123
STBY
OFF
Autopilot model
Software V(ersion) and R(elease)
Hardware revision
Junction unit model
Software V(ersion) and R(elease)
Self check
Main board revision
Primary Display
123
RFC
12
Secondary Display
Standby mode.
Current heading from RFC
compass.
HI speed selected.
Rudder angle: 12 degrees
to starboard.
Standby mode.
Current heading.
22083083H