View Parameters - Simrad AP35 Instruction Manual

Simrad AP35 Autopilot
Activate the AUTOTUNE, by rotating the course selector clockwise.
After the Autotune has been completed the rudder must be controlled
manually, as the mode is returned to STBY.
When the Autotune has been completed, there should normally be no need
for further adjustments. On certain installations, however, you may want to
"fine tune" the parameters after the Autotune due to the special steering
characteristic of a specific boat. Viewing or changing the Autotune
parameters are done from within the VIEW PARAMETERS menu item.
Exit the Seatrial Settings menu by pushing STBD [>] button to proceed to
the View parameters menu, or press STBY to return to normal AP35
operation.

View parameters

A boats steering parameters found by Autotune can be looked at and if
needed changed under this menu item. The steering parameters can also be
set to values manually instead of performing an Autotune. The parameters
are divided into two sets:
• HI = Steering parameters for automatic steering at HI speed
• LO = Steering parameters for automatic steering at LO speed
The RUDDER value in WORK mode is shown as a separate item.
86
INSTALLATION
Automatic
tuning?
INSTALLATION
Automatic
tuning
INSTALLATION
View
parameters?
INSTALLATION
Autotuning
confirmed
22083083H