Installation; Mechanical Installation; Communication Engineering Tool (Cet); System Requirements - ABB SPA-ZC 400 Installation And Commissioning Manual

1MRS755347
3.
3.1.
3.2.
3.2.1.
3.2.2.
Ethernet Adapter
Installation and Commissioning Manual

Installation

This chapter describes the installation of the SPA-ZC 400 module and the
Communication Engineering Tool (CET). For additional information, such as
technical data, maintenance and service, refer to Chapter 5. Technical data and
Chapter 6. Maintenance and service.

Mechanical Installation

Connect the SPA-ZC 400 module to RE_54_ and screw SPA-ZC 400 to the 9-pin
type D-connectors. Connect the fibre optic LAN cable to the LAN connector of
SPA-ZC 400. The other end of the cable is connected to the IEC 61850-8
Station bus via Ethernet switch.

Communication Engineering Tool (CET)

System requirements

Communication Engineering Tool (CET) runs on Windows 2000, Windows XP and
Windows Server 2003 Operating Systems. A PC capable of running one of these
operating systems and applications is usually sufficient also for CET. For more
information, refer to the Section 1.8. Related documents. The detailed system
requirements can be seen below.
• 20 MB free hard disk space, if Microsoft .NET Framework 1.1, which is required
for running CET, has been installed already.
• 100 MB free hard disk space, includes installation of Microsoft .NET Framework
1.1. It is installed automatically, if it is not found.

Installing CET

1. Close all the open programs and insert the CET installation CD to the CD-ROM
drive of your PC.
2. The Installation program starts automatically. If this is not the case, open the
program by browsing it to the CD drive and start setup.exe.
3. First, the installation wizard extracts the installation files to your local computer,
see Fig. 3.2.2.-1.
Fig. 3.2.2.-1 Extracting installation files
SPA-ZC 400
A040005
19