Accessories And Consumables - MINOLTA-QMS magicolor 3100 Installation Manual

Symptom
You can't
print a
status page.
The printer is
printing
codes or not
printing at all
when in ESP
mode.
Error
message is
displayed.
Printouts
seem faded
on one side
of the page.
The colors
appear to be
misregis-
tered.
If you've followed all of the instructions and still have problems you can't
solve, refer to the User's Guide or see the Service & Support Guide for the
MINOLTA-QMS office closest to you.

Accessories and Consumables

Contact your local vendor or www.minolta-qms.com for purchase information,
parts numbers, and pricing. Consumables for your printer are available from
your local vendor or Q-SHOP (www.q-shop.com).
Accessories and Consumables
Cause
The tray does not have
media.
The printer's cover isn't
closed securely.
There is a media jam.
The printer emulation is
not correct.
Your ESP timeout is too
short.
A unit or tray is not cor-
rectly installed.
The media is jammed.
A problem occurred inside
the printer.
The printer is not on a
level enough surface.
The side-to-side color
registration was not
adjusted after the printer
was installed.
Solution
Check that the media trays are
loaded with media, in place, and
secure.
Make sure the cover is closed
gently and securely. Avoid jarring
the printer .
Check for a media jam.
Reconfigure the port to the specific
printer emulation of the file you are
trying to print.
If a PostScript file prints PostScript
statements while the printer is in
ESP mode, increase the ESP
timeout in the Administration/
Communications/Timeouts/ESP
Timeout menu.
Handle the message according to
the message display.
Level the printer surface. It should
not exceed ±5° slant in any
direction.
Adjust the registration in the
Administration/Engine/Registration
menu on the control panel. Refer to
"Color Registration" on page 23.
45