MINOLTA-QMS magicolor 3100 Installation Manual page 48

Symptom
No lights or
messages
appear on
the control
panel.
The Online
indicator is
on and the
message in
the display is
"IDLE," but
no startup
page prints.
The startup
page comes
out skewed.
The printer
is not
receiving
data from
the com-
puter.
(The Data
indicator
doesn't blink
after a file is
sent.)
44
Cause
There is no power supply
to the AC outlet.
The power cord is not
plugged in securely into
both the power outlet and
the printer.
The printer is not
turned on.
The line voltage from the
power outlet doesn't
match the printer's power
requirements.
You did not wait long
enough.
The media guides are not
accurately set in the
media tray.
The printer is not on line. Put the printer on line and verify
The emulation has been
changed from ESP to an
emulation that doesn't
match the file you are
sending.
The port setting is
incorrect.
Solution
Make sure there is power supplied
to the AC outlet.
Turn the printer off, plug in the
power cord securely, and then turn
the printer back on.
Turn on the printer.
Make sure the line voltage matches
the printer's power requirements.
Refer to appendix A in the User's
Guide.
The printer takes approximately 6
minutes to warm up the first time.
Be sure you wait long enough for a
startup page before suspecting a
problem. This 6-minute warmup
only happens when a new imaging
unit has been installed. Normal
time to warm up from a cold start is
approximately 1½ minutes.
Reset the media guides.
that the message window displays
IDLE.
Print a status page. For information
about the ESP mode, refer to the
CrownBooks .
For Ethernet or parallel
connections, set the port to
Enabled.
Troubleshooting