Inverter/Charger Installation
AC OUT
Battery
System
Bonding Wire
(if required)
See Table 2-6 on page 2–14
for torque values for the
inverter battery
connections.
Actual cable and grounding
requirements may vary.
_Battery Connections -EU.vsd/SI no BOS/April 10, 2008
Torque connections to the battery terminals according
© 2007 Xantrex Technology Inc .
to the battery manufacturer's recommendations.
Figure 2-11 DC Connections to a Single Inverter
Installing the Battery Temperature Sensor
2–18
GRID
(AC1)
AC IN
AC IN
L
N
L
N
L
N
AC
GEN
LOAD
(AC2)
Hybrid Inverter /Charger
(+)
(–)
Circuit
Breaker/DC
Disconnect
The Battery Temperature Sensor (BTS) regulates battery charging based on
battery temperature. Installing a sensor extends battery life by preventing
overcharging in warm temperatures and undercharging in cold temperatures.
The BTS is supplied with the Xantrex XW Inverter/Charger. The replacement part
number is 808-0232-02.
This manual for use by qualified personnel only
BTS Cable
DC
Disconnect
(+)
(–)
ON
OF F
Fuse
FU S E
FU S E
C LA S S
C LA S S
T
T
Block
300
300
A MP
A MP
(optional)
Negative/
Ground Bus
Battery
(–)
(+)
Battery
Negative (–
Positive (+)
Ground
Battery
975-0384-01-02