Xantrex Xw Conduit Box; Xantrex Xw Solar Charge Controller - Xantrex XW4024 230 50 Installation Manual

Xantrex XW Conduit Box

Xantrex XW Solar Charge Controller

975-0384-01-02
The Xantrex XW Conduit Box (Part Number 865-1025) is available to enclose the
bottom of the Xantrex XW Inverter/Charger and protect the cabling. Use of the
conduit box may be required depending on the local electrical code. Consult the
local electrical authority to make sure the installation is code-compliant.
Figure 1-4 Xantrex XW Conduit Box
The Xantrex XW Conduit Box comes in two pieces and mounts directly to the
bottom of the inverter/charger with keyhole slots and screws. It is secured to the
inverter by two #10-32 screws on the bottom of the inverter, and it is secured to
the wall by two screws (not provided).
Internal wire barriers (or raceways) are included to keep communications wires
separate from AC and DC power wires. The Xantrex XW Conduit Box also
includes multiple cable strap points.
The Xantrex XW Solar Charge Controller (Part Number 865-1030-1) is a 60 amp
charge controller with integrated Photovoltaic Ground Fault Protection (PVGFP)
and separate Battery Temperature Sensor. The Xantrex XW Solar Charge
Controller can be used with 12-, 24-, 36-, 48-, and 60-volt battery systems. When
the Xantrex XW Solar Charge Controller is used with the Xantrex XW
Inverter/Charger, it is limited to 24- or 48-volt battery banks. The Xantrex XW
Solar Charge Controller automatically detects the 24- or 48-volt settings.
Figure 1-5 Xantrex XW Solar Charge Controller
This manual for use by qualified personnel only
System Components and Accessories
1–5